Wired Panel "Whips"

Our "Panel Whip" category is dedicated to pre-wired options for loading into panels. These are often referred to as "panel whips" or "panel tails" because of the cabling that comes directly off the back of the connector. We will wire the cable "tails" to whatever length you specify. This will help keep your rack or pedalboard nice and neat.

These are all using solder (or crimp type, where applicable) connectors. These style of panel connectors are often preferred over the "feedthrough" style of connector as they feature one less connection point for failure within the signal chain. Also, they do not have the chance to have a connection point wiggle loose while on the road or at a gig.

If you have an existing panel with pre-punched ports and would like to add a connection - this is the spot for you! If you are looking to cut a D-series hole into something (i.e. side of a pedalboard) - this is the spot for you! However, if you are looking to outfit an entire panel and purchase the panel + each connection point a-la-carte, this is the not the spot for you. You can surely do this; however it will end up costing much more than it should. If you are wanting a pre-wired panel from scratch, please email us at sales@btpa.com or check out our pre-wired panel page.

Bestsellers