3 Port Pedaltrain Panel with (2) 1/4" Locking TRS/TS Feedthrough Connectors and (1) PowerCON Input to Right Angle IEC C13 Connector
The panel comes with the (2) 1/4" Connectors not installed. The PowerCON connector will be installed to the panel and the line cord will be crimped with the needed lugs. After installing the Panel to the pedalboard, you will need to install the Power Cable to the PowerCON Connector. This is easily done as you just need to slide the lugs on to the tabs of the PowerCON Connector. Please see our PowerCON Installation Instructional Video for more information. The PowerCON used is the Neutrik NAC3MPA-1 connector, or Power In. It is preferable over a standard IEC as it features a locking connection. The right angle IEC features a "right side cable exit."
The panel is setup standard as ports 1-2 as 1/4" and port #3 as the PowerCON. If you'd like this differently on your order, please specify on the customer notes when ordering. The Power Cable is measured from the back of the panel to the end of the IEC Connector.
If you need a PowerCON Cable to mate with this panel, please see our custom length pre-made option, POWER10-XX If you want a PowerCON to install to any existing power cable you have (no soldering required), please check our MC-0831 connector.
This product works on all CURRENT Classic and Novo models of Pedaltrains. It will not fit on legacy Pedaltrain 2 or Pedaltrain 1 models. Higher feet must be added to the board for this to fit on Legacy Pedaltrain 2 and Pedaltrain 1 models.
Wondering how to install to your Pedaltrain? Check out our Side Panel Installation Instructional Video